IOCELL Networks 351UNE Uživatelský manuál stáhnout pdf (Strana 8)

IOCELL Networks NetDISK User Manual Network Direct Attached Storage / NDAS

IOCELL Networks 352UN can be configured in different RAID configurations via NDAS.

However, only one RAID configuration is accessible via USB. See the table to

understand how to use the 352UN on both the Network and by USB.

Configuration Access Disk A (Right Bay) Access Disk B (Left Bay)

Single Drive via USB Yes No. A single drive must be

placed in the Right Bay.

Single Drive via NDAS Yes No. A single drive must be

placed in the Right Bay.

Two Drives as standalone disks

via USB

Yes, appears as local disk Yes, appears as local disk

Two Drives as standalone disks

via NDAS

Yes, appears as local disk Yes, appears as local disk

Two Drives in device as

Aggregate (JBOD)

NDAS Only. 2TB total size limitation.

Two Drives in device as Striped

Array (RAID0)

NDAS Only. Total size limited to the combined capacity of the

hard disks.

Two Drives in device as

Mirrored Array (RAID1)

USB or NDAS. Changes made

to this drive by USB will

synchronize when the Mirror is

mounted RW via NDAS.

NDAS Only. Changes made to

this drive by USB will be over

written when the Mirror is

mounted RW via NDAS.

Two Drives in device one

standalone, one added to a

different NDAS RAID

Either drive may be added to any other NDAS RAID configuration

leaving the second drive as a standalone. The standalone drive

would be accessible by USB or NDAS.

2.3 eSATA Mode

The eSATA port has the highest precedence. Any other connection will be terminated

when the eSATA wire is connected to the 351UNE.

Note: NDAS software does not need to be installed to use in eSATA mode.

1. Connect the included eSATA cable from the eSATA port on the NDAS device to

your PC’s eSATA port.

2. Make sure the power connector is connected firmly to the NDAS device and

connect the power adapter to a power source.

3. If your NDAS device has an On/Off switch, press the On/Off Switch to ON

position.

Note: Multiple Disk NDAS device may have special requirements for eSATA operation if

the drives have been configured in a RAID. Please read the Bind Management section

carefully if you will setup your drives in RAID configurations.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 78 79

Komentáře k této Příručce

Žádné komentáře

IOCELL Networks 351UNE Uživatelský manuál Strana 8

Komentáře k této Příručce